[ovs-discuss] How to use Openflow

[Justin Pettit]

Please read INSTALL.Linux and the ovs-vsctl man page.

--Justin


On Dec 6, 2011, at 7:53 PM, Pankaj Rawat wrote:

> I would like to setup a network where I would use a PC2 as a controller a PC1 as a macine being controlled
> openvswitch is already installed in PC1 I would like to know the steps which I have to use in order to control the machine PC1 By PC2 via open flow .
> what are the ovs command which are needed to run on Pc2 to create a datapath and what needs to be done on PC1 in order to control the switch on PC2
> DISCLAIMER: 
> ----------------------------------------------------------------------------------------------------------------------- 
> The contents of this e-mail and any attachment(s) are confidential and
> intended 
> for the named recipient(s) only.  
> It shall not attach any liability on the originator or NECHCL or its 
> affiliates. Any views or opinions presented in  
> this email are solely those of the author and may not necessarily reflect the 
> opinions of NECHCL or its affiliates.  
> Any form of reproduction, dissemination, copying, disclosure, modification, 
> distribution and / or publication of  
> this message without the prior written consent of the author of this e-mail is 
> strictly prohibited. If you have  
> received this email in error please delete it and notify the sender 
> immediately. . 
> -----------------------------------------------------------------------------------------------------------------------
> 
> _______________________________________________
> discuss mailing list
> discuss at openvswitch.org
> http://openvswitch.org/mailman/listinfo/discuss