[ovs-discuss] how to enable inband communication
sharon_sachin at yahoo.co.in
Sun Feb 19 03:03:46 PST 2012
Do I also need to enable in-band stuff at the datapath ports as well? I just added the datapath port as explained in INSTALL.Linux and then setted up the controller as you explained in last mail. I am not observing any packet exchange in the tcpdump output of datapath ports. My set up is => switch A, B and C connected in a linear way and the controller is connected to switch B. So in this setup, I am interested that the controller traffic of the switch A and C should go via datapath ports connected to switch B.
From: Ben Pfaff <blp at nicira.com>
To: sachin sharma <sharon_sachin at yahoo.co.in>
Cc: "discuss at openvswitch.org" <discuss at openvswitch.org>
Sent: Wednesday, 15 February 2012 6:04 PM
Subject: Re: [ovs-discuss] how to enable inband communication
On Wed, Feb 15, 2012 at 08:02:05PM +0530, sachin sharma wrote:
> I found the design of inband communication at openvswitch via DESIGN
> file in the openvswitch. However, i did not find the exact steps to
> configure this in our switches.
In-band control is enabled by default when you configure a controller.
You can use "ovs-vsctl set-controller <bridge> <controller>" to
configure a controller.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the discuss